High-performance Industrial Ethernet Switch

1. 10/100Base-T/TX Ethernet ports, adaptive, full/half duplex, Auto MDI/MDI-X connection

2. 100Base-FX fiber ports, single mode/multimode, full duplex

3. High speed redundant ring network(recovery time<300ms)

4. Alarm relay output for power.

5. Store-and-forward switching mode conforms to IEEE802.3/802.3u/802.3x

Industrial Power

1. Industrial power input of DC24V.

2. Reliable protection for EMC and against over-current/over-voltage.

3. Redundant power input.

Rugged Design

1. Ribbed heat-removal design(fanless); operation at -35℃ to +75℃

2. Solid IP40 housing

3. Easy DIN-Rail mounting or optional wall-mounting

100Mbit/s Optical Fiber Redundancy

It is critical for network to re-configure immediately once disconnection occurs in the industrial fields. Accordingly, it comes with DT-Ring, and offers 2 redundant fiber ports to realize the redundant ring network. The system will be able to reconfigure within 300ms after connection fault.

LED Indicator

The LEDs of the front panel indicate the port status correctly including transmission rate, link status and system status.

Layer-2 Switching

Switches work in two ways: Cut-Through and Store-and-Forward. In Cut-Through, a data packet is immediately relayed further after detecting the target address; in Store-and-Forward, a data packet is first read in completely and checked for errors before the switch relays the same. It employs Store-and-Forward that is a switching mode widely used.

Power Alarming

Any power of the switch fails, alarm signal will be sent out by alarm terminal. The terminal is open when there is no alarm and is closed when alarm occurs.

Technique index